DAB ROBERTS Specifications download pdf (Page 12)

Using the sound system for the ﬁ rst time

1. Place your sound system on a ﬂ at surface and connect the loudspeakers

to your sound system (see page 9).

2. Fully extend the wire aerial located on the rear of your sound system.

The wire should be fully extended and positioned for optimum reception.

3. Plug the mains lead into the mains socket located on the back of your

sound system ensuring that the plug is pushed fully into the socket.

4. Plug the other end of the mains lead into the wall socket and switch

on the wall socket.

IMPORTANT: The mains plug is used as the means of connecting

the sound system to the mains supply. The mains socket used for the

sound system must remain accessible during normal use. In order to

disconnect the sound system from the mains completely, the mains

plug should be removed from the mains socket outlet completely.

5. When your sound system is ﬁ rst switched on the clock display will

show 0:00 and the unit will enter the standby mode.

6. When a signal has been found, the display will show the correct time.

7. If a signal has not been found it may then be necessary to relocate

your sound system to a position giving better reception. You should

then carry out an autoscan to ﬁ nd stations as described on page 13.

USB

AUX IN

SPEAKER

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

No comments

DAB ROBERTS Specifications Page 12